Why equipment fails
Most failures have ordinary causes: missed lubrication, dirt and contamination, loose fasteners, wear that nobody noticed, running outside design limits, or a repair that fixed the symptom. Each of these leaves early signs such as noise, heat, vibration or leaks, so most failures can be caught before they stop production.
How to do it, step by step
- List and rank your assets. Mark the equipment whose failure stops output, harms people or damages quality. Start with those.
- Set a maintenance plan. Use the manufacturer's recommendations and your own history to schedule preventive maintenance, then do the work on time.
- Add daily operator checks. Short clean, inspect and lubricate routines, the core of autonomous maintenance, catch loose parts, leaks and wear early.
- Watch condition where it pays. For critical rotating equipment, track vibration, temperature or oil condition. See condition-based maintenance.
- Record every breakdown. Log the asset, symptom, cause and downtime. Without a history, repeat failures look like bad luck.
- Fix root causes. For any failure that recurs, ask why until you reach something you can change, such as a lubrication standard or an operating limit.
- Keep critical spares and review daily. Hold parts for the assets that matter most, and look at overdue maintenance and yesterday's stoppages in the daily meeting.
Maintenance approaches compared
| Approach | When work is done | Best for |
|---|---|---|
| Run to failure | After it breaks | Cheap, non-critical items |
| Preventive | On a fixed schedule | Wear with a predictable pattern |
| Condition-based | When measurements show decline | Critical, expensive assets |
Common mistakes
- Letting planned maintenance slip whenever production is busy.
- Replacing the failed part without asking why it failed.
- Leaving operators out of equipment care.